The National Fluid Power Association (NFPA) has
established standard port sizes for hydraulic cylinders to go along with standardized bore sizes.
Cylinder ports are threaded holes that can be
located on any of the four cylinder end cover side locations. The
port contains standard thread dimensions to accept hydraulic
fittings (used to introduce hydraulic fluid into the cylinder)
commonly found in industrial applications throughout North America
and elsewhere around the world. A port may be located on any side
of the cylinder head and cap end covers.
Hydraulic supply ports may be occasionally be
oversized; however, when this occurs, the cylinder becomes
"Non-NFPA Standard" and is generally not NFPA
interchangeable when compared to other NFPA cylinders.
Oversized
Ports are not configurable herein.
When selecting Port Locations for
Double Rod End
Cylinders, please contact Peninsular.
Illustration #1:NPT Ports and SAE O-Ring
Ports
-
are the most commonly used Standard Hydraulic
Supply Ports
NPT Ports
- Have Tapered Threads
SAE O-ring Ports
- Have Parallel Straight Threads
Illustration #2:NPT Ports
- High Pressure Hydraulic
Standard NPT Supply Port illustration and Dimensional Data
NPT Ports
- Have Tapered Threads
Dimensional Data for
NFPA Standard NPT Ports
Illustration #3:SAE O-ring Ports
- High Pressure Hydraulic
Standard SAE O-ring Supply Port illustration & Dimensional Data
Note: Port Bosses are
Required for Oversized Ports
Very few applications may require a larger port
than the stated NFPA standard port size. When oversized ports are ordered,
a “Port Boss” is welded to the cylinder head to accommodate
the larger supply port.
Oversized NPT Port Sizes are available by special request and are
not configurable within this configurator. NPT Oversized Port
dimensions containing bosses are referenced below. When oversized
ports are required, contact Peninsular at Toll Free (800) 526-7968 in the
USA or Canada or at (586) 775-7211. You may also email
us at
sales@peninsularcylinders.com.
Chart listing
Oversized NPT & SAE O-ring Port
Size Dimensions
Informational Data Only - Oversized Ports are not configurable
herein
Illustration #5:Selecting End Cap Hydraulic Supply Port Locations
The purpose of this configurator screen is to
identify the “Head End” (Front End Cap) and "Cap End" (Rear
End
Cap) side locations that require hydraulic supply ports. A
hydraulic supply
port may be located on any one, two, three or four of the four
sides of the square end cover of the cylinder that is not resticted by the cylinder mount. When
selecting the port location, one must always view the cylinder
through the front of the “Head End” (also referred to as the "Rod
End") even when selecting the port location on the "Cap End". The
illustrations below provide an explanation on how to
view the cylinder for making the port location(s) decision.
When selecting Port Locations for
Double Rod End
Cylinders, please contact Peninsular.
End Cap Hydraulic Supply Port Location Charts
End Cap Side Positions
View of a Side Foot Lug Mounting
Style cylinder (MS2) showing both the Front & Rear End Caps with Hydraulic Supply Ports at
Positions #1.
Arrows are pointing to the End
Cap Side Locations
For any cylinder mount, always
view the Cylinder through the Front End Cap when determining
the Hydraulic Supply Port location(s) for both the Front and
Rear End Caps.
If you need any assistance please feel free to call us toll free
at (800) 526-7968 in the USA or Canada or at (586) 775-7211. You
may also e-mail us at
sales@peninsularcylinders.com.